Attaching and removing the panel

Procedure for attaching the panel to the mounting base:

1. Holding and supporting the panel in your hand, connect the connection terminal (s).
2. With a gentle movement, keeping the panel parallel to the wall, put it on the upper hooks.
3. Holding your fingers on the sides of the panel at the bottom, gently slide it upwards as far as possible.
4. Gently press the panel against the wall.
   
   ATTENTION:
   Do not apply pressure if you feel resistance!
   Check if the screws are fastened correctly in the upper catches and that all the screws holding the mounting base are tightened and their heads do not protrude too much to fit under the panel housing.
   
   
5. Check that nothing flexes, and when the panel is released, it remains in its place.
   
   ATTENTION:
   If the panel does not stay in place, correct the arrangement of the wiring in the box and follow the remark in point 4.
   
   
6. Using a Torx screwdriver (T6), carefully tighten the locking screws (2 pcs) the panel on the mounting base.
7. Verify the installation effect - the panel should fit snugly against the wall, a minimal, even gap is possible.

Procedure for removing the panel from the mounting base:

1. Using a Torx screwdriver (T6), unscrew the locking screws (2 pcs) of the panel on the mounting base.
   They are located at the bottom edge of the panel.
2. Holding your fingers on the sides of the panel at the bottom of the panel, lift it slightly away from the wall.
3. Slide the panel all the way down to unlock the top hooks.
4. Remove the panel from the mounting base with a gentle movement from the wall.
   
   ATTENTION:
   - Properly positioned panel does not jam on the mounting base.
   - If the panel gets stuck at the top when removing, place it more vertical (almost parallel to the wall).
   
   
5. Holding the panel in your hand, gently disconnect the connection terminals.
   You can use a small, flat screwdriver to pry them off.